Help! I'm looking for a wiring diagram for the Ananda mc5-b0 controller

[Retsmit]

I Bought a bike write recently and am investigating the possibility to install front and rear lights connected to the controller to be able to turn them on and off via the display.. I've looked everywhere for a wiring diagram without any luck. Can anyone help me?

 

[vfr400]

You don't need a wiring diagram. They're the same as a y other controller. If you're not sure what anything is, show photos of what you have - that's wires, connectors and LCD, not labels.

 

[Retsmit]

You don't need a wiring diagram. They're the same as a y other controller. If you're not sure what anything is, show photos of what you have - that's wires, connectors and LCD, not labels.

Really? as any other controller? Because I have been searching quite a bit and so far I have found quite alot of different diagrams, sometimes where a connector with a black wire and a white wire are shown as front light and other times where the connector is shown as used for brakes.

 

[vfr400]

OK suit yourself. Good luck with it.

 

[sjakob52]

Btw can you tell me if mc5-bo has connections for front- and backlight. There is no permanent light on my bike (mustang danish)

 

[thelarkbox]

Btw can you tell me if mc5-bo has connections for front- and backlight. There is no permanent light on my bike (mustang danish)

Even if provided for, only fit manufacturer supplied lights for your bike Or confirm the switching capacity of the light circuits is beyond the draw (Amps or Mamps) of any light you fit. Otherwise you risk blowing the switching component loosing light control and possibly further unpredictable problems as a consequence.

Or just use one of the many standard bike lights with rechargeable or replaceable batteries