Kuberg freerider hall sensor problem

[Lukkyg82]

My Kuberg motor hall sensor came loose and broke in side the motor, I have tried everywhere to get a replacement even Kuberg can’t supply 1 they sel
Just the motor at a cost of nearly £1000. Could anyone help me locating 1 of have a motor forsale?

 

[vfr400]

Hall sensors are standard parts, cost pence and you can get them from anywhere.

You can repair that board with UV glue, then scrape off the green stuff from the tracks either side of the break and solder wires to then.

You can fix anything with this glue.

30GR PLASTIC REPAIR UV RESIN,GLUE FOR GLASS,PLASTIC,CHARGING CABLE FIX,UV TORCH | eBay

It is best to cure in layers, uv light need to penetrate in to uv adhesive, use a small amount first cure it with uv source, repeat the process. For a full cure it needs 2-3 hours. 9 LED TORCH WORKS WITH 3X AAA BATTERIES (NOT INCLUDED).

www.ebay.co.uk

Hall sensors. there can be minor differences between them. Read the designation of yours and post it here so that we can advise you which exact ones to get:

ss41 hall sensors for sale | eBay

Find great deals on eBay for ss41 hall sensors. Shop with confidence.

www.ebay.co.uk

 

[Lukkyg82]

Thanks for replies I will try and fix with that uv glue will save myself a lot of money if it works as I was thinking it would need a anew motor.

 

[vfr400]

Thanks for replies I will try and fix with that uv glue will save myself a lot of money if it works as I was thinking it would need a anew motor.

To use the glue, push and hold the two ends together, then drizzle some of the glue over the joint. Activate it with the UV torch. Turn it over and do the same on the other side. Maybe then add a second layer to each side for extra strength. This stuff is like very hard and strong plastic. Applying it is a bit like a welding process.