Hi All,
My kirbebike kit as turned up now ( still waiting on the battery though) so I'm about to start to go for it and put it all together, I have no knowledge about doing this type of thing but I've been watching plenty of videos on YouTube lol so I'll give it a go and see what happens.
I've been advised to use thread lock on the rear axle bolts and the torque arm bolts to stop the vibration loosening them off and to tighten the axle bolts to 60nm.
My question is can anybody recommend me some good torque arms and where to get them from please?
I've seen some 3 or 5mm thick ones ( 2 piece) that fasten with 5mm bolts into the holes in my dropouts, are this type any good?
The motor will put out between 1500- 2000 watts so I'll use 2 of them.
If you can think of any more advice that will help me out I would be grateful.
Thanks in advance for any advice.
My kirbebike kit as turned up now ( still waiting on the battery though) so I'm about to start to go for it and put it all together, I have no knowledge about doing this type of thing but I've been watching plenty of videos on YouTube lol so I'll give it a go and see what happens.
I've been advised to use thread lock on the rear axle bolts and the torque arm bolts to stop the vibration loosening them off and to tighten the axle bolts to 60nm.
My question is can anybody recommend me some good torque arms and where to get them from please?
I've seen some 3 or 5mm thick ones ( 2 piece) that fasten with 5mm bolts into the holes in my dropouts, are this type any good?
The motor will put out between 1500- 2000 watts so I'll use 2 of them.
If you can think of any more advice that will help me out I would be grateful.
Thanks in advance for any advice.
