Latest activity
-
Sturmey replied to the thread Don't get no respect. Wife doesn't like new conversion..I think I can see your wife point of view. 220W may not enough at times and may be too much at other times. I think the motor rpm is... -
Nealh replied to the thread Pedal assist not working.If PAS works in back pedal mode then one simply needs to flip the mag disc face over , magnets as one likely knows have a N or S face . -
Ddaverave replied to the thread Carrera Vulcan E Bike E42 Fault.I just purchased the Julet cable from ebay....im still waiting for some of the tools to dismantle the motor from ebay.
-
Ddaverave replied to the thread Carrera Vulcan E Bike E42 Fault.Hello....I will take on board what you said concerning the Julet 9 pin connector....i have now disconnected the wheel and all electrics...
-
Cadence replied to the thread Don't get no respect. Wife doesn't like new conversion..Maybe it's the wrong colour, or it's just plain ugly. After nearly fifty years I've come to realise that the more I second guess how to... -
-
PThat's perfect 260 rpm to get good power and efficiency at 15 mph.
-
harrys posted the thread Don't get no respect. Wife doesn't like new conversion. in Conversion Kits General Discussion.I converted this ultra step-thru Biria for my wife, figuring she would appreciate the EZ-on/EZ-off . Used a Q128 rear motor. 20A KT... -
-
harrys replied to the thread Modifying to Torque Sensing.This is a typical Hall sensor throttle. Just a 3 pin IC that faces the magnet bar. Close up of the magnetic sensor chip. It gets...
-
-
saneagle replied to the thread Carrera Vulcan E Bike E42 Fault.You can only buy motor cables with the Julet 9-pin connector. It's up to you what you do with it, but one thing you can't do is plug it... -
saneagle replied to the thread Modifying to Torque Sensing.There are two types of hall sensors: Bi-polar ones (SS41)are on/off 5v and switch when a magnet passes. They're typically used as...
-
saneagle replied to the thread Help! My next project.The controller and motor can't change anything from the wheel size setting. That setting only effects the speed display. Set the wheel...
-
saneagle replied to the thread Help! My next project.That's perfect 260 rpm to get good power and efficiency at 15 mph.
-
saneagle replied to the thread Pedal assist not working.You can use any of the KT LCDs except LCD1, which is, I guess ,the one you have. The 12 magnet pedal sensors are often handed, so you...
-
thelarkbox replied to the thread Pedal assist not working.There are a number of ktlcd displays as well as some 'dumb' led displays, The ktlcd-03 is popular, i use a ktlcd-10 (very similar)... -
Jjbenn43457 replied to the thread Pedal assist not working.Hi, I've got a couple of pas and have tried the magnetic ring all ways. I believe I need to get into the c settings menu, but my display...
