Latest activity
-
TTony1951 replied to the thread The Anything Thread that is Never off subject..Apologies - I somehow omitted to paste in the source story...
-
TTony1951 replied to the thread The Anything Thread that is Never off subject..Stop quoting chat gpt in every post you make. Post your own comments not the output from a machine. Educators in this country have been...
-
TTony1951 replied to the thread The Anything Thread that is Never off subject..Is thirty months in jail a just sentence for acting like an obnoxious oaf? This man as was noted by the court: did not commit an act...
-
vidtek replied to the thread Pedelec Law - The Details.It is possible some bright spark will come up with a voice command to interact with the controller, it shouldn't be that hard to do. I... -
Nealh replied to the thread Display unit or controller fault?.An incidental tug on the display cable may cause a wire to become detached. A twist of the bars and a tight cable another scenario. -
TTony1951 replied to the thread The Anything Thread that is Never off subject..Trump's Visit to the UK "A group called the Stop Trump Coalition are planning protests in both Windsor and London during the...
-
-
Nealh replied to the thread Kt 3 lcd meter setting help wanted..Check your PAS disc set up , make sure the magnet disc is very close to the sensor head and the magnets are 1mm or less gap to the...
-
Nealh replied to the thread Kt 3 lcd meter setting help wanted..All the KT's I have used have always given me PAS rotation with less then 1/4 movement and to be more exact nearer 1/8 rotation. One can...
-
Nealh replied to the thread Kt 3 lcd meter setting help wanted..For a speed control device aka a thumb or twist throttle then to be legal set P4/1 & C4/3 this allows legal throttle use under pedal...
-
saneagle replied to the thread Kt 3 lcd meter setting help wanted..Torque simulation is current control, where each selected level gives a different current (power). The alternative setting is speed... -
TTony1951 replied to the thread Display unit or controller fault?.There are far better informed experts around here than me (I'm a user not an expert) but if it was mine, I would examine and wiggle...
-
Nealh replied to the thread Kt 3 lcd meter setting help wanted..P4 /1 provides current control , each PAS level giving a max level of current. Speed is max in each PAS level. P4/0 provides speed...
-
Nealh replied to the thread Display unit or controller fault?.Even if one found the same display , it will unlikely be compatible as the firmware/software/programming will be different. A broken...
-
saneagle replied to the thread Display unit or controller fault?.This is the situation for most Chinese bikes. I'd need to see your wiring to confirm that it's the same for yours: The LCD works...
-
TI think it was more likely the BMS. In ball-park figures, typical pack resistance = 200mOhm (approx and varies widely), 10A -> 20W of...
