Recent content by djbarnat

Hi all, Please help me! I have a freego raptor (24v) which I use for my daily commute. The battery is not performing like it used to and tends to run out now just before the last hill on the way home. I have access to 36v 13ah battery from a conversion kit I bought before i got the raptor...

Motor cut out on the way to work this morning :( . Back to the drawing board. New PAS sensor is worth the cost to rule it out so will be picking one up.

D8veh, sorry not sure how to quote a post an Tapatalk. The PAS sensor is lined up correctly and was working fine on the bike I took it off of. However if this 202 setting proves not improve matters I am going to replace it next. Sent from my NEM-L51 using Tapatalk

The P1 setting is definitely having an effect on how my q100 motor runs. The kit originally came with a different motor and P1 setting was 88. When I replaced the original motor with the q100 the q100 was running way to slow at 88 and the speed read out was way too high. The higher I set set P1...

Thanks Nealh for the helpful post. Will give these settings a try tonight. Sent from my NEM-L51 using Tapatalk

Ok I have made an assumption that because my motor is labelled and being for a 20" wheel that my motor is the 328 rpm version and set the P1 accordingly. However, intermittently I am still getting the odd time that the motor stops immediately after I start pedelling. I have no throttle so all...

This is what I've got. So it's a sensor motor? Everything seems run ok apart from the motor seeming a bit noisy and rough. I took it out today on a gravel path and a couple of times the front wheel lost traction and slipped and then the motor would cut out and require me to stop pedalling for a...

Ok as best I can tell it is about 125mm diameter (4.92 inches). I also found it carries a code engraved in the motor bbz3620a. Not sure if this helps? Sent from my NEM-L51 using Tapatalk

Does the photo I provided in my original post not give this information ? It is labelled aikema akm-13. I have no idea at all how to determine whether it sensor or sensorless. Sent from my NEM-L51 using Tapatalk

Hi there I have now received this motor but I think my kt-lcd parameter needs some adjustment. I am trying to determine the correct P1 setting but I don't know how to find out the number of alnico magnets. Any pointers? Sent from my NEM-L51 using Tapatalk

Doesn't to bad then, will give it a go, thanks ! Sent from my NEM-L51 using Tapatalk

Thanks folks. This will be going into a 20inch folding bike and is already set into a 20 inch wheel. Its used and seller is asking £65 for wheel and motor. He says the motor has covered about 100 miles. Do you think it's worth it? Sent from my NEM-L51 using Tapatalk

Hi I have this controller kt36zwsrt-lcd I am looking at purchasing this motor to fit in a folding bike. Does anyone know if they will be compatible?. The connection looks the same but that is about as far as my knowledge extends.

There is also the "speedict"

Flecc. Now you have pointed that out and I have read the sentence a second time I am not sure why I didn't come to the same conclusion myself. Thanks for the clarification :)