Recent content by Dodd

Dave, or not Dave?, I had previously tried getting the gap down to almost contact, as my understanding from the kit instructions was that a sufficiently small gap was required. Apparently not so. I suggest you give a wide gap a try.

FWIW, increasing the sensor-to-magnet gap to 22-24 mm cured the problem I had experienced of reading 62 mi/hr at low speeds, which in turn had been preventing the pedal assist function from engaging. I don't imply that this gap is optimal. I was surprised the sensor worked with such a large...

I've finally just taken a good shakedown ride on my bike with a TSDZ2 750 watt kit motor that I installed. What a wonderful experience! But, the pedal assist does not come on until I reach a speed of about 10 mi/hr. Above that speed, the assist behaves nominally - proportional to my pedaling...