Recent content by Brobert99

Hi guys. I have a BBS02 750w 48v motor that I’ve been powering using a 48v 17.5Ah Panasonic with no issues. However the battery is a bit big and cumbersome for using on shorter journeys and I am looking for something smaller and more compact, accepting the capacity will therefore be less...

Thought I would just update my post in case anyone else was looking to convert the same bike. I went with the BBS02 750w 48v motor from PSWPower and a 48v 17.5Ah Panasonic NCR18650GA Tiger Shark battery from ebikebatteries. After a bit of wrestling and gentle persuasion removing the bikes...

So i have decided to go for the BBS02 which i have ordered from PSW power and should hopefully be here in a few days. Decided to wait until i can confirm the motor will fit before ordering the battery. I have been looking at this one on PSW power, and just wondering if any one has had any...

Hi Neal I measured the distance from the BB underside to the cup and it is about 6mm. The depth from the weld to the cup is approx 8mm and the depth from the plastic cable guide to the cup is approx 12mm From what I can gather online the tsdz has a clearance of 7mm so I reckon will be too...

Thanks Peter, I was afraid that may be the case. It’s a 68mm BB with a 44t single narrow/wide chainring. I am fairly sure the cables are sleeved all the way through the down tube and out the bottom bracket so it should be easy enough to remove the guide to help with clearance. i am fairly...

Thanks guys, looks like the Bafang may be the best option then. @tommie what size of battery do you have on there and what kind of range do you get? I have toyed with bbs02 but not looked much into the bbshd, will take a look at it.

Thanks Nealh Does the TSDZ need to be hard up against the bottom bracket then? Is there any scope to put a compressible foam or such like between the bottom bracket and the motor to account for the weld and cables or do you think a Bafang would be better suited? Thanks again

Some photos attached

Hi, I have been following the forum for a while and reading various build threads and issues with installing the TSDZ2 and Bafang BSS02. I have a Whyte Glencoe which has 1x11 SRAM gears, and looking to install either of these two motors. From what I have read there may be two issues with the...