Recent content by Creative Native

I think that on some displays you can adjust the amps (Cycleanalyst v3)? Not sure whether this adjustment is available on the KT-LCD3 (Y01)? According to the KT-LCD3 instruction manual, Parameter C5 = "Controller maximum operating current adjustment mode". The various adjustments are given in...

Sorry for the delay in replying, I've been down the pub!! The controller label reads: Model: KT36ZWSRTD-EP01 Rated Voltage: DC36V Rated Current: 8A Low Voltage Protection: DC30 +/- 0.5V Maximum Current: 17 +/- 1A Speed Set: Hall Sensor Brake Input: Low level I assume from the above that I...

Thanks for all the response. Unfortunately, I'm as thick as a whale omelette when it comes to electronics. Are you saying my 36V controller will work with 48V excitation or do I have to purchase a 48V controller and limit it to 18A? Topbikekit appear to sell a few variants. I understand...

Two reasons I left off the PAS: 1. The mtb was fitted with a Octalink crank bearing and Shimano cranks. I did not want to purchase a Sq taper bearing and cranks when the octalink setup was in good nick. 2. Just using the thumb throttle allows me to use the battery power in an instance, if and...

Hi All, I introduced myself on the forum section the other day, so I won't go into my background again. Suffice to say, I have purchased a Yosepower 36V 350W rear hub kit complete with KT-LCD3 (Y01) display and 8A rated controller with a max output of 17A +/- 1A. The battery is a 36V 18Ah 1200W...

Hi All, Prior to major lumber decompression surgery 7 weeks ago, I would cycle a daily round trip of 8 miles to work and back. In order to ease myself back in to full recovery and fitness, i purchased a Yosepower conversion kit and fitted it to an old Diamondback Sorrento SE steel frame I had...