Recent content by Mark Lester

i am buying a new crank because it leaks grease into the clutch and i now cant get the securing clip off as both eyes came off. a chain ring for a shimano 11 speed has alternate facing teeth. yes the entire groupset bar the crank wheel is official shimano. I will ring darren tommorow morning...

thanks steve. sorry about the PS, yes that was my previous adventure trying to get to the clutch. it was full of thick grease and shouldnt have been, so this crank was poorly to start with I think. you cant run a shimano 11 speed chain on a standard chain ring. the consensus I am getting is...

humf, well OK then, I have a 7 speed already, i was having probs indexing the thing to get the big wheel but thats cos I am learning everything. But you are telling me this fancy pants chain wont work, and indeed I should get a proper ebike one anyway. mucho obligo. I will just get the crank then.

PPS, I just got a cheapy cassette so have been able to run about, but now we are down we may as well do it right, you do need a proper fat rear cassette when it goes a bit alpe d'huez.

One of my problems was that I had got a fancy pants 11 speed cassette and the special shimano chain obviously, a normal one wont hold on the cassette and will doubtless damage it. But then I realized why the chain was breaking every time i went up a decent hill, and then even getting to the end...

well yes, but then we've a problem, its only done 400 miles. its just going to happen again. at least we can get in and out and i have a spare but i am presumably losing a seal somewhere.

I am fairly sure the locking teeth on this clutch will only go on one way anyway, which is reassuring. My chum thinks it should go back like it looked, i.e with grease on. I am suggesting my yellow bike grease as a compromise. I need to go get a replacement 5th screw before we put it back...

i got a new ring. i will clean this one up, its full of this thick grease btw, which yes, doesnt help much. i am trying to build a touring saloon, off road is anything you could physically get a wheelchair along, e.g. tow paths, decent bridle paths.I put 35mm tyres on but along with the shed...

i think it wlil go either way, but i am not putting this back together just yet. will bike grease do or do i need to get some special stuff ?.

i guess the feet want to be pointing against my direction of pedal, which is anti clockwise as we look at it, so the pawls want to be pointing clockwise. btw, as diagnosed, the problem is a sticky pawl. one of them isnt as easy going as the other two. i'm sure its a tiny bit of sand.

ok we're in, my rubber mallet did the job. my only problem now is i took the clutch ring out, and now cant remember which direction the bugger goes!

car shop got the 5th bolt out of this large gear wheel. i was expecting the cover/housing of the clutch to just come off now. i cant find any vids of this bit, i will examine and try to lever it out.

I dropped it off at my friendly car repair guys, he said he'd get it out so here's hoping. Also, I forgot to report that there were no seals between the two locking nuts. Once I got the damned seal thing off the front it was just a very tight locking nut (may be the circlip tool i have now...

i got the retaining ring off, and removed the plastic cover, and 4 of the 5 screws on the clutch housing proper, and i now have one last bolt that looks like its been drilled against the thread. well it aint moving. this is the last obstacle i think, *sob*. i will clean all the grease off, will...

so we're down to a securing circular clip thing on the end of the shaft keeping the housing for the clutch secure. how the hell do you get those off, what's it called even https://www.dropbox.com/s/c5txae327bbw9wg/DSCF0074.JPG?dl=0