thelarkbox's latest activity
-
Pin 1 has a direct connection to the battery positive wire going into the controller, so it can't really have missing voltage unless the... -
thelarkbox replied to the thread LcD Display.lcd10? OK, I will get my coat..
-
thelarkbox replied to the thread Making a torque throttle instead of a speed throttle for a cheap controller.once you have the pots set to the levels desired remember its a high impact environment mounted on a bike.. a dollop of hot glue...
-
thelarkbox replied to the thread Yose power.The kt controller Julet connectors are compatible with yose-power motors, and sensors, thumb throttle, but Not the c500 display. You...
-
thelarkbox replied to the thread Controller KT-36ZWS-XFC01F Problem.First confirm the battery is in good condition fully charged and isnt dropping volts with a nominal draw, bad cells or dodgy bms could...
-
thelarkbox replied to the thread Bluetooth pairing.hack on new antenna, both modules are probably employing pcb antenna, and if using off the shelf coms modules ( probability high?) at...
-
thelarkbox reacted to NewPaul's post in the thread Battery and controller swap on shop bought bike? with
Like.
Thank you for help. While bike still has minor things to finish I followed advice and now it's 48v 20amp controller (limited to 15amp... -
thelarkbox reacted to Garry Hallam's post in the thread Review of Argos £245 E-move folder with Agree.
The display controller is playing up on my bike. I will check connections but It will not power off sometimes without switching off at...
-
thelarkbox replied to the thread Recommendations please for books, sites, courses and other resources for ebike knowledge please ..Welcome and have fun. The Grin ebike co from canada host a site with a good deal of reference info and guides www.ebikes.ca The gist...
-
thelarkbox replied to the thread YosePower eBay kit.Spend £5-10 on brake cut off sensors for adding to hyraulic brakes. A doddle to fit and will ensure no unwanted motor over runs in...
-
thelarkbox replied to the thread I have a Yose power front wheel conversion kit is it possible to change assist level's in the computer, I find the level between 2 and 3 to big..Some Yose Kts supplied 2 years ago also came with the inside hailong battery base JytCon? controllers which are pretty much locked down...
-
thelarkbox replied to the thread Regarding Yose conversion power kit.Perhaps some pictures and measurements could help anyone with specific knowledge advise. -it depends how much material/support you...
-
thelarkbox replied to the thread Newcomer from the US.With the suggested front brake upgrade,:cool: the rest of your plans seem very well suited to your needs. Although with zero mid drive...
-
Don't remind me! I haven't had steel rims this century but I remember them in the rain. I'll seriously think about front disc brakes...
-
thelarkbox replied to the thread Newcomer from the US.Pretty much my attitude to my rim brakes pre conversion, Now with brake adjustments required weekly if not daily, and black brake block...