Search results

PC2017 YOSE are sending a new pas sensor so i will wait to try that before cutting any plugs of, but i am going to order the controller and will go with your recommendation of the KT-D12L pas sensor as it is good for a hollowtech crank, i just haven't got round to it yet work and playing in...

This is the controller I am thinking of ordering I know it is 22amp but in another thread I read, it was Nealh I think he side you could reduce the amps from the lcd 3, this is the battery I went with (enerpower-hailong-pro-36v-frame-li-ion-battery-1750ah-diy-ga-charger-4a) as I wanted to try...

PC2017 Thanks for the offer but I think I will go with VFR400 suggestion and cut the plug off and solder the wires and use a bit of heat shrink round them. I have been in correspondence with YOSE they asked for a picture and have passed it on to their engineer’s we shall see what transpires. I...

Thanks for the input PC2017 you were spot on I have bent a pin on the connector one of the holes in the male plug looks to be obstructed and when I pushed the plug together I bent the pin, ore that’s my excuse anyway, it looks like I will be using the throttle for a bit. Also thanks vfr400 for...

This is the pas sensor supplied in the kit (Cable:52cm W/O connector Dual hall sensor,12 signals output)and is an integrated all in one item, I have taken the crank arm off to check that it is sitting right up to the crank and it is secure and when you turn the pedals the inner turns. I...

Thank for the reply, sorry for the delay in replying as you may have gathered I am no wheel builder so thanks for putting me straight, I have another problem you may be able to advise me about I have had my first ride on the bike and have set the throttle to come on independently of the...

Thank you for the prompt reply and the link, I will send for 1, I will get it in June lol, you are right there is not a lot of thread showing on the nipples so not a lot of movement to play with, I have made a spreader to open the back of the frame, this allowed me to play about with the...

i have been following this thread with interest and i am fitting a yose hub i had to shift the wheel over to alow the chain to index onto the outer gear to work, this has meant i will need to dish the wheel about 3mm to center it i have tried a 2mm spoke key, this was too small i then tried a...