Search results

Well the white jack from controller was not the same as the motor was. The one with 6 wires. So I had lying around one that was exactly matching that one and it was the negative, perfect match. But it came with wires already, not the same color order like controller. I matched the motor color...

Thanks for all the support! . Yes I used the pas sensor in the boost jack and it's working. I have a lot of wires lying around on the bike, but now I can start and get everything nicer. It seems the bike is working with electric motor assistance. I do not know yet if I'll use the throttle...

Thank you for all support! Due to the problems I have I did not made any permanent wires connections. There are some wires that are not the same color with the schematic. I made it that way to change wires between more rapid and simple. I do not took all the wires and try them in a random way. I...

The pas sensor from the bike has yellow(which is ground) red for+ and blue for signal. I found this on internet. Yes because I can change speed of the controller from lcd choosing level for assistance I'm assuming too that white , red and black is for throttle. Already tried to switch to boost...

The black socket with black red and blue is the boost connection

Here is the pas sensor. It has yellow(-) red(+) and blue(signal). There are 5 magnets. The boost I did not intend to use it and I do not have a device for acceleration.

I tried to mount the pas sensor to the boost terminals. Nothing happened. I only have to touch the pas sensor to one magnet and the motor starts. And it stops when I start pedalling

I'm sorry, you are right! I'll give you as many pictures you want. Please tell me what picture do you want!

Here is the wiring. Actually I do not know what boost is. Maybe there is a mistake in the manual

Hello! I have this controller with lcd : https://a.aliexpress.com/_mOgYRMJ with 250w rear drive motor. Well I do not know where to start, because the motor works only when I do not pedalling also it's enough to start the motor only to touch the pas sensor of one of the magnets. I can also change...

Yes, your ideea with resistor is very good. Have you identified the send and return data wires on this device? I have opened once but I do not have the pictures now... I'm curios if I can make it work with a lcd-sw900. I do not have so many electronics knowledge and I'm new to electric bikes...

I do not have the control panel. Adding a potentiometer between green and red will solve the control problem?

hello guys! I have the same controller and I started the bike based on your infos. But to select the type of motor spining where you get 1V, 2V, 3V or 4V? from red wire? that voltage is measured from black to green?