Search results

No, it doesn't. Would it be possible that the PAS is the other 3 wire connector (white, black, red)? In attachment: - the controller with wirings - the PAS connection with blue, black, red wirings

This was my first try, but did not work. To be sure: I try the PAS pedaling forward for 4-5 cycles, is it correct what I do? I also just measured with a voltmeter between red and black on controller side (without PAS) and found 4,5ish V. Thanks.

In attachment the wirings --> I saw that this is the PAS controller from the dealer's pic (also attached here). You will also find a picture of the complete controller wirings and my bike PAS Thanks for suggestions. P.S. I tried all 6 combinations of colors with and without "cruise wiring"...

I did try the 6 combinations, but the wheel is not moving when pedaling. Do you see other possibilities/trials? Thanks

I would keep the red with red at least, what do you think?

controller picture and screenshot from amazon dealer where I bought it

this controller is without LCD screen

I received today a new controller (by the way I realize that the model has same number!) that was assured to work with sensorless motor. I mounted the battery and the motor cables and did the self-learning: it worked! I then switched off battery and disconnected the self-learning cables. Then...

hi Spinnanz, I saw your answer only now, sorry. I did give the controller back, now I am trying with another one.

Just tried the self learning procedure 4-5 times. The good news is that now the battery symbol is visible (full battery shown) and the only remaining error is E10. When I switch on the display there is a counting 00:02, 00:03, 00:04, and then E10 is displayed --> see attached pictures. The...

I bought it on Amazon, it is not specified if it works with both sensored and not sensored. Reading in the Amazon Q&A: - one person wrote that it doesn't work with not sensored motors - another one said that it works also on motors without hall sensors Shall I try self learning or is it...

I don't know what you mean.. where should I check if it could work sensorless? No I did not do self-learning procedure (never connected the two green single cables). Thanks

Good morning, I am new in this forum. I have a 2010 ebike with a Tongxin controller burnt. I changed battery pack last year therefore I am trying to replace controller with Brainpower Poewer controller and S866 display I read a lot of very interesting info in this forum before starting to do...