Hi all, I was moving the cables around on my bike yesterday. When I plugged the green 5 pin connector back in I must have twisted it and it bent the pins causing them to short and cause a flash! (In hindsight I should have taken the battery off but I didn't...!) I've hand to strip back the connector to try a crude repair of the wiring and everything tests ok with a multimeter but now when I power it up the C961 display comes on but then displays error code 30 and nothing works. I've ordered a new cable but I've got a feeling I've killed something else. Is there any way to prove whether it's the LCD display or the BBS02 controller that is at fault? I've also ordered a programming cable if that's any help.
Thanks in advance, Mike. (Cracking forum by the way!)
Thanks in advance, Mike. (Cracking forum by the way!)