Today I fitted my Purion controller and finally ditched the brick Intuvia. All went relatively well- there's a stupid bolt on the plastic sump guard highest up the downtube which when undone lets the nut fall into the frame amongst the battery mountings and all the cables....total faff to get it out. Also the frame grommet needed cut as there was no way the connector was going through the small diameter hole, but now it's back in place you'd never know....
So- replaced the 2 motor>frame gaskets and currently I've torqued(not a ratchet one but Park "bendy bar"(!) the 3 larger bolts on the RHS to 25Nm, and the 2 on the left hidden under the cover by the electrical connections to 11Nm Using a Park ratcheting torque wrench?
Anyone got a more accurate idea of what it should be and/or whether this is ok? All bolts seemed really easy to take out btw? I've based them figures on Googling but they may be for the Active Line??
So- replaced the 2 motor>frame gaskets and currently I've torqued(not a ratchet one but Park "bendy bar"(!) the 3 larger bolts on the RHS to 25Nm, and the 2 on the left hidden under the cover by the electrical connections to 11Nm Using a Park ratcheting torque wrench?
Anyone got a more accurate idea of what it should be and/or whether this is ok? All bolts seemed really easy to take out btw? I've based them figures on Googling but they may be for the Active Line??