I've been repairing this motor with some great help on this forum .
I checked cables and MOSFETs . Then discovered I needed to replace all 3 halls .
I did that and the motor ran again .
But when I put all back together it ran ok for 200 yds then stopped .
I then noticed it pulsed briefly when you turn the wheel .
I discovered this was a symptom of faulty hall sensor. Even though I'd just replaced them I checked them from the controller end and all showed voltage when turning the wheel dropping back to zero after .
So I don't know what's next . As I say it worked fir 200 yds then something happened . Any clues advice please ?
I checked cables and MOSFETs . Then discovered I needed to replace all 3 halls .
I did that and the motor ran again .
But when I put all back together it ran ok for 200 yds then stopped .
I then noticed it pulsed briefly when you turn the wheel .
I discovered this was a symptom of faulty hall sensor. Even though I'd just replaced them I checked them from the controller end and all showed voltage when turning the wheel dropping back to zero after .
So I don't know what's next . As I say it worked fir 200 yds then something happened . Any clues advice please ?