Recent content by Bobbington

. Hi Nealh, Checked my C1 settings, its now running correctly (On Stand) for some reason the initial numbers - 1,2. didn't sort the problem. So as you reminded me about C1 numbers are 0- 7, the only number that worked was 7... I've yet to road test. So fingers crossed its now OK.. AGAIN! Bob.

. Hi Nealh, I'll try the other C1 numbers today. My settings paper only had 1 & 2, scribbled down for C1

Hi Nealh, Thanks for your response. I did press C10 Restore system, earlier in the investigation which may have been the start of this problem ? I have been putting the settings back to some scribbled down settings I made a few years ago. So think the settings are not correct. It may be just one...

Hello all, Not been on here for some time as everything has been going OK. I have the relatively old Display ..KT-LCD3. Issues 1st started when I attempted to switch from KPH to MPH. At first it would not run, (I must have pressed something I shouldn't) finally got it running . But it just...

Sorted... KT-v12L PAS sensor, Kapput! after 250 miles.

Tried the C10 reset but didn't save the setting properly so it didn't reset. I've started to think could it be the pedal Crank sensor ?

The only instruction that came with the kit for the KT-LCD3 was a small 4 page Pamphlet with basic display info. totally inadequate for settings.

Hello again everybody, Got another problem, related to my previous thread. (slowing walk speed down). In the end there was no option but to switch to Km/ h on the KT-LCD3 display. Which involved alot of "unnecessary"messing with the settings Doh !. Which worked well Hanging from the Garage...

One more thing While I'm on Here.....Can my controller that came with the 250W kit (26in Wheel), Handle a 350W Motor? I was thinking I would swap my Kit over to My 27.5 inch MTB . Then Purchase a 27.5 inch wheel with a 350W motor to a few Quid ?

Hi All, It would appear from all messages I've received that it is not possible to change the walking pace speed, Its 6 & stuck with it!... so just set the KT-LCD3 to KPH, walking pace is now 6 KPH. My Heart & I can keep up with that.

I see what your thinking but I'sure its 6MPH....6KPH (under 4MPH) would be much easier.

I think your correct. the question is can this be changed if in mph? I suspect Not from the reply's.

I assume walk speed of 6 is the same in MPH & KPH, if it is possible to change this value to say..5 or 4 I could keep it on MPH. I feel sure the speed setting of 6 is the same in MPH & KPH.

Hmm, interesting thought. It should be as "factory" 36v not touched anything in that area.