control wireing of kalkhoff

[yogiellis]

WIRES TO GO INTO A KALKHOFF CONROLLER , ANY ONE KNOW HOW THE WIRES GO , 5 WIRES ,
BROWN , WHITE ,YELLOW , GREY , PINK , GO INTO( WE,BR ,GN,GE,RO ) ANY HELP WOULD BE GRATFUL . THANKS

 

[Deleted member 4366]

we is white
ge is yellow
br is brown
ro is re
gr is green

 

[yogiellis]

thanks a lot , just need to sort the grey and the pink , one is ro the other gn
thanks again

 

[Deleted member 4366]

With the battery switched on, measure the voltages of each wire to ground. The one with battery voltage will be ro.

Don't let any of those wires touch each other.

 

[yogiellis]

Thanks so the other wire will be gn , thanks very much for your help on this
matter and have a great weekend

 

[Deleted member 4366]

Grey is also gr (grau).

 

[yogiellis]

thanks but I only have a gn setting , don't have gr on my wiring . Thanks

 

[Deleted member 4366]

It looks like gr in the photo next to ro!
Gn is green (grun).

 

[yogiellis]

It looks like gr in the photo next to ro!
Gn is green (grun).

Sorry did not read properly , yes I have we,br,gn,ge,gr,ro = 6, but I only have 5 wires brown ,white ,yellow,grey , pink . Thanks again for helping me on this

 

[Deleted member 4366]

Hmm! That's weird because all the pads look like they've had a wire on them. Starting from the outside end:
White
Brown
Green
Yellow
Grey
Red

So you should be able to figure out which wire is missing, then you have to figure out what's happened to it. According to what you wrote, it would be green that's missing, but I can see a green in the photo! Has the missing one snapped off where that cable-tie is?

 

[yogiellis]

Thanks the last wire is pink , not red , I think that I only need 5 wires , battery x2 , lights x2 (lights & power ) 1 wire is a pas signal wire , also checked wires there is only 5 wires , not to sure , so do you think by putting a test on wires will help with it . Thanks again for your help