Search results

I'll explain what i did so far,,, I put 12 volts onto the wires for the front wheel motor and it powered straight away. I put 4.5 volts onto the throttle and tested,on low it was .9volt and full throttle,it was 4.5 and 2 volt in the middle. I fitted three new batteries,(12v 14ah). Ignition is...

Just to be clear,,,when you say the controller ,do you mean the throttle

Nealh,is it possible to check circuit board (controller) on this bike? I got the new batteries and the motor doesn't start.

You should be able to see the back wheel sensor if zoomed

Cheers

I'll post a picture of the rear wheel tomorrow

Thank you nealh, So,would the sensor test be almost the same test as used for the throttle (3x1.5 batteries)and spin wheel and rotate pedals. The type of sensors are as per photos above

Thank you nealh, Yeah,thats a good idea and i will take your advice. The new batteries should be here late next week,,, hopefully. As a matter of interest,what would your opinion be of the powabyke euromodel be Its the after 2007 model???

Just to clear something up,,, I wrote above,that the three wires on the ignition that i queried was(blue green and red) When in actual fact,it was (blue,green and yellow)

Thank you

Powabyke euromodel

Hi all,i've just acquired a powabyke euromodel oldie. I am hoping,semebody can help me with some technical stuff. There does'nt seem to be much information out there. The bike's batteries are shot,but i'm organising new ones. They charge full,but almost immediately,they drain to four lights...