Hi.....some time ago I bought a good 2nd hand Benelli Achle 29"....my old legs needed a bit of help. Recently, the rear hub motor packed in (Bafang 36v, 250W) and, after finding that virtually NO e-bikes were in stock, I opted for a replacement hub motor. I got a Bafang 36v 250W G020 and had it fitted. Yes...it works, but not too well. My old 800S display (that only ever showed the PAS setting and the battery indicator, the speed and odometer showed "zero") suddenly sprang to life but gives erroneous speed figures - I surely can NOT pedal at 99 mph - and only the 1 setting on PAS gives any power....and not very much. Tried the obvious settings on the display (wheel diam etc) but no joy.
Reading your website I wondered about C and P advanced settings, but can not get them on my display.
Is there a display out there that will communicate with the controller and let me see which settings need to be adjusted?
Not sure, if like mid drive units, the controller/motor can be connected to my laptop either.
Yes....my bike works, but it is nowhere near as good as it was before the new motor was fitted......help.....summer is here and my auld legs are getting worn to a frazzle.....
Reading your website I wondered about C and P advanced settings, but can not get them on my display.
Is there a display out there that will communicate with the controller and let me see which settings need to be adjusted?
Not sure, if like mid drive units, the controller/motor can be connected to my laptop either.
Yes....my bike works, but it is nowhere near as good as it was before the new motor was fitted......help.....summer is here and my auld legs are getting worn to a frazzle.....