Hi I am making my son up a mtb using a bafang motor coupled to a sukura scooter controller both 200w as its the only brushless one I got have conected the the 5 hall coil wires block terminal directly to the controller and the 3 sensor wires to the same colours the same on the controller as I used the old wiring loom from the scooter for ease of convenience ( ha ha ) and put the ig lock back in plugged bits back in controller as I found out where they went.
I have tried power but to no avail, but am not sure on the 3 sensor wires being correct as they dont always match up on the colours
The controller has no spare terminals except those in the picture
a question or two in the pic I there are 2 leads I pesume brake cut outs, these leads can be joined together, so I wondered if that is what I need to do as the brakes dont have cutouts on them on the bike. Also if there is a pedal senor lead how do I spot it and disable it please?
Any help for knowledge, diagrams or info appreciated
many thanks
Fatts
I have tried power but to no avail, but am not sure on the 3 sensor wires being correct as they dont always match up on the colours
The controller has no spare terminals except those in the picture
a question or two in the pic I there are 2 leads I pesume brake cut outs, these leads can be joined together, so I wondered if that is what I need to do as the brakes dont have cutouts on them on the bike. Also if there is a pedal senor lead how do I spot it and disable it please?
Any help for knowledge, diagrams or info appreciated
many thanks
Fatts
