Zeerover

II opened the engine to install 3 hall sensors. There was already 1 for the speed with a white wire. I also changed the motor cable because the hall sensor wires were not there either. The speed is indicated perfectly correctly when I select 1 magnet at P07. I can also select 20x5 = 100 magnets, but then there is only the correct speed when the motor is rotating. In the meantime the engine is running well after I changed the maximum speed P08 from 30 to 100 km / h, very strange. Thanks for thinking along.

No, that's not the problem. Speed setting is 1 the white cable.

I have something very strange. My engine runs very slowly in pass mode, even at full throttle. In walk mode the motor runs normally. When I connect the learning wires the motor also runs very slowly but if I go to settings P20 with the learning wire connected, I can run the motor quickly at P20 1,2,3 at 0 the motor turns slowly again. When I save the settings at P20 1,2,3, the motor runs normally but this is not usable. I probably did something wrong with the settings, but because the manual is so unclear I tried just about everything to make the controller work, probably with bad results. There are no error codes. Hopefully someone has a solution

I accidentally activated the code on the S866. Every time I have to enter this at start-up. After a lot of searching I also found how to turn it off again. Change the code to "0000" and you do not have to enter it at start-up.