bloggs

Just looked at the products you mentioned. I will be purchasing the marine grade heat shrink and also the aerosol electrical tape. Thanks for the info.

Thats great information. I will definitely look into this. Thanks for all the info.

Thanks everybody for all your replies.

Thanks for that. I was thinking along the lines of what you said, using heat shrink, ie: heat shrinking each individual wire then one larger piece of heat shrink over the whole lot. I think heat shrink is brilliant stuff but in my experience of using heat shrink it doesn't necessarily make wires water tight. I have found in the past that water/moisture can still find its way between the heat shrink and wires due to capillary action. It could all end up more trouble than its worth. Heat shrink doesn't actually bond itself to the cable, where as a moulded connector does. So, back to my original question, "Hi, does anyone know where I can get Julet 9 pin connectors only without the cable?"

Thanks for the reply. The problem is that if cut the moulded connectors off and soldered my motor cable to it, it would then no longer be waterproof. Looking like I will have to dismantle the motor and fit a new Julet cable to it. Thanks.

Hi, does anyone know where I can get Julet 9 pin connectors only without the cable? Its for the 3 phases plus 6 pins for hall's and temp sensor.