Recent content by gordon581

  1. gordon581

    Waterproofing Electronics - This may help

    Looks fantastic stuff. As I commute all year by my ebike, this might help me get through the wet winter.
  2. gordon581

    Big Bear Hub Jamming

    Well, I got my wheel back yesterday and installed it today after work. I've taken on board all your advice as I fitted it. Strangely, during a test ride it was quieter than its ever been before, even when new. Hopefully it will stay like that.
  3. gordon581

    Big Bear Hub Jamming

    Thanks everyone for your advice. Having ridden cycles all my life, I am quite surprised how temperamental ebikes can be. I will give serious thought to your tips to ensure water stays away. I may even give up riding when its heavy rain. Thanks for the pics Nealh.
  4. gordon581

    Big Bear Hub Jamming

    TBH I can't say for sure how it goes until I get it back and have a look
  5. gordon581

    Big Bear Hub Jamming

    Any chance you could upload a picture sometime to see how you did that? I'd like to do the same.
  6. gordon581

    Big Bear Hub Jamming

    My cable has always gone down the fork where it connects halfway down, then continues down into the wheel. I've just looked at the pictures on the website and they are the same. The connection seem quite tight and it has always been dry in there anytime I looked.
  7. gordon581

    Big Bear Hub Jamming

    I do basic cycle maintenance such as brakes etc. I know little about electrics. I live in Glasgow and it rarely stops raining here. I do cycle most days throughout the year and only move over to a regular cycle in the snow and ice because I have spiked tyres for it.
  8. gordon581

    Big Bear Hub Jamming

    Yes, it's always under a shelter both at work and home. The only time it's getting wet is when I'm riding in the rain
  9. gordon581

    Big Bear Hub Jamming

    An update to my wheel. At considerable cost I sent the wheel back to woosh to check it out. I've just discovered an email from them asking for me to pay an extra £20 because there was considerable water ingress and I must have used a hose or pressure washer on it, or stored it in the rain when...
  10. gordon581

    Big Bear Hub Jamming

    It feels almost exactly like that and is noisy pulling backwards. Trust my luck. Probably the most expensive fault. Thanks I appreciate everyone's help. It means I can get it fixed quickly
  11. gordon581

    Big Bear Hub Jamming

    Thanks, I've checked every connection and even stripped the wires out of the frame to make sure they werent damaged. Thanks Nealh, that was a great help. I had always wondered about that white wire connected to the grey and black. Sadly though, the problem is as bad as ever and my bike is...
  12. gordon581

    Big Bear Hub Jamming

    Opened it up and checked what I could and it all seemed fine but problem still as bad. I wish it came with a wiring diagram as there are a lot of unused wires mixed in. Will try again tomorrow
  13. gordon581

    Big Bear Hub Jamming

    A good point I've had the controller disconnected a few days ago. I had to remove all the wiring to have a poorly welded joint repaired
  14. gordon581

    Big Bear Hub Jamming

    Hi, The latest of a million problems I've been having with the Santana Big Bear. This seems like the most serious. Travelling to work today, when the motor engages in the front wheel it shudders noisily and squeals as though its jammed and engaging power breaks it free. No problem when I'm...
  15. gordon581

    Stuttering Woosh BB

    Sorry in the delay in replying. I've been without a pc for a few weeks. Thanks for the advice, I never found out the exact cause but since bringing it indoors for a couple of days, and spraying WD40 around the electrics, its not happened since.