In the last few days my UM36 had been occasionally cutting out on full and empty battery, throttle and pedal sensor, so today I opened the section below the battery pack on the bike and set to on disconnecting & re-connecting each of the controller connectors (apart from the battery & motor bullet connectors) a few times to help the contacts make better contact.
On the short distance I test it things seem to be going ok *fingers crossed* as my 1yr warranty ran out today I think
But the interesting part was one of the connectors hanging out the control unit plugged back into itself, a single white wire with a connector on the end that plugs into another white wire.
So I disconnected the white wire from itself & twisted the throttle with the back wheel off the ground, *whizzzzzzzzzzzzzzz*! derestricted! Another short test run and the throttle appears to get me up to the 15mph pedalling speed along the flat and probably faster (still no speedometer yet), unsure if it's derestricted on the pedal sensor side of things so will find out on the way home, should be a fun ride
On the short distance I test it things seem to be going ok *fingers crossed* as my 1yr warranty ran out today I think
But the interesting part was one of the connectors hanging out the control unit plugged back into itself, a single white wire with a connector on the end that plugs into another white wire.
So I disconnected the white wire from itself & twisted the throttle with the back wheel off the ground, *whizzzzzzzzzzzzzzz*! derestricted! Another short test run and the throttle appears to get me up to the 15mph pedalling speed along the flat and probably faster (still no speedometer yet), unsure if it's derestricted on the pedal sensor side of things so will find out on the way home, should be a fun ride
Last edited: