Hello - I have just taken delivery of a GNG 36v Gen 2 kit. Previously I have only installed a heinzmann kit - not many wires just a few connectors to plug in.
The GNG has a few more wires. I'm at step 1 which is changing the connectors to bench test the motor with my 36v battery. I am using neutrik 4 pole connectors but getting no activity so far.
There are wires labelled as key lock with switch + as well as PAS and Brake.
I was hoping I could just ignore these and just connect the 2 wires from the battery straight to the control.
The battery is charged and throttle connected.
Any advice much appreciated.
The GNG has a few more wires. I'm at step 1 which is changing the connectors to bench test the motor with my 36v battery. I am using neutrik 4 pole connectors but getting no activity so far.
There are wires labelled as key lock with switch + as well as PAS and Brake.
I was hoping I could just ignore these and just connect the 2 wires from the battery straight to the control.
The battery is charged and throttle connected.
Any advice much appreciated.