Hi Guys (and Gals) I am fitting a kit.
I would like to fit my sensor disk on the chainwheel side,(where it would be hidden) trouble is I can't remove the bottom bracket nut (the one with 2 flats on), tried the usual punch/screwdriver method (I am pretty sure it's a l/h thread). I could fit it on the left side but it would'nt look so neat (it's 60mm dia) plus it would be a bit exposed to damage, on the other hand I suppose if it's on the right it could get seriously damaged if the chain came off ??. The bike is a Dahon Espresso. Would appreciate your comments. Thanks a lot. Eddie, Ding-dong)
Just seen IanA's very usefull post with photo's so will do similar if no replies. Thanks. & thanks IanA
I would like to fit my sensor disk on the chainwheel side,(where it would be hidden) trouble is I can't remove the bottom bracket nut (the one with 2 flats on), tried the usual punch/screwdriver method (I am pretty sure it's a l/h thread). I could fit it on the left side but it would'nt look so neat (it's 60mm dia) plus it would be a bit exposed to damage, on the other hand I suppose if it's on the right it could get seriously damaged if the chain came off ??. The bike is a Dahon Espresso. Would appreciate your comments. Thanks a lot. Eddie, Ding-dong)
Just seen IanA's very usefull post with photo's so will do similar if no replies. Thanks. & thanks IanA
Last edited: