Recent content by Mappier

I was hoping for advice on upgrading the display and controller.

In 2020 I bought and fitted a modestly priced conversion kit (front hub 48v 250w 48v battery) and it has performed ok but I feel it would benefit from a bit more power. The display is a very simple 900S and the controller is rated at 7A - 15A max. It's fairly hilly where I live so I would be...

Here is a sketch showing wire connections coming from the controller. Should I be concerned that black AND orange connect to the middle socket?

Yes the bike has always had the old style HiGo connectors which have an orientation flat rather than a pip. I've just checked the loom for continuity and there is a path between the socket in the connector going to the display, which I had as not being used, to a pin on the 9 pin connector...

Here is a picture of the eight wires coming away from the controller into the loom. You can see the end of the purple wire as it enters the loom. That's how it has always been.

There is a CR2032 battery inside the display which I did thought was just for the clock but perhaps it supplies operating power as well. At the controller end of the loom I can see the purple wire which is cut off as it emerges from the outer insulation.

Hi Neal, I'm having trouble identifying which pins to jump. A while back I fitted a new wiring loom with HiGo connectors hoping that was causing the error 30 so I have a spare loom. I cut the 5 pin Higo connector off the old loom and the wire colours are not the same as you describe. See below...

Thanks Neal I'll try that tomorrow. Jim

Thanks Neal. I am led to believe the new display may be one of a faulty batch so I haven't 100% confidence in it. I've read elsewhere it may be possible to bypass the display by fitting a jumper between two of the connector pins; is that worth a try? If it is which two pins?

Andy has been snowed under all week, I thought somebody on here might help.

Thanks Woosh but I didn't have any of the sensors connected. Am I right to suspect the controller if two of the wires (black and orange) coming out of it are shorted?

A bit of advice needed please. The J-LCD display on my son-in-law’s crank driven ebike packed up, I replaced it but got an error 30. Hoping it was something simple like the wiring loom that comes from the controller up through the frame to the handlebars I replaced that but still got the error...

I took the bike(Woosh Sirocco Sport CD 2013) for an extended trial ride and there are still two problem issues. Using PAS on the flat or on hills motor power is cut momentarily for no apparent reason after all the power indicator bars on the display are lit. Thinking back to when I fitted the...

Thanks vfr400. I connected the self-learn wires together and raised the back wheel of the ground, switched the battery and display on. The motor ran but I think the drive sprocket went backwards and the cranks didn't rotate. I switched off and disconnected the self-learn wires. Switched back on...