Search results

I’ll send it but note as in other replies the Ali board has no R1 or R2

Motor is dead ever since wheel dropped out

You know guys whatever the differences in my board to others it worked great before wheel dropped out. Continuity first then I’ve got to decide if board has SM components replaced or buy new board on Ali . BUT NOW I SEE THAT Ali BOARD HAS no R1 And R2. Ok stick with it cable continuity test Sunday .

A Well meaning But absolute incompetent frankly got his hands on it . Told me he could help and apart from the terrible soldering he totally guessed what to do and replaced sensors without even checking them . I’m told he replaced them with wrong type 49e . Then he replaced a faulty what I...

It’s bit of a minefield this . wheezyriders motor has wires connected to q4 mine doesn't have those connections but it worked fine without them. The replacement board on aliexpress didn’t have R1 and R2 components. But as you said , forget the board for now . I need to try and get beep test...

There no connector near the wheel. the cable runs directly in to the board . I’m sure there will be some kind of connector at the controller . I’ve not seen it . The problem if any with wiring will Be at the wheel end after it came off. Whatever is at controller end it was fine before wheel came off

Do you think it would be worth fitting a plug connector close to the wheel because any damage should be only in the cable nearest to the wheel ?? Then it’s easier if I need to remove wheel and also easier to check between the solder and the plug contacts . What would you advise please Mike I...

Ah I think I need to clarify if I’ve understood well . 1. I can test directly from the soldered wires on the board but not by putting both probes to each solder point 2. I need to have one probe to solder point and other to connection to controller I was trying to avoid removing the cowling...

Sorry I didn’t see this reply I replied on your other post Thanks

Well I want to eliminate the wiring first because things have happened ref other things which I’ll explain later . Is the wiring ok ? Dies the beep test work this way if the wiring is directly soldered to the PCB and there’s not a plug connector ? Cos I’m not a regular with these circuit testers

the cable is threaded directly into the axle and soldered to the board . thereS no plug connection . so can I beep test each soldered cable on the board Se e photo

The cable doesn’t unplug At the wheel end This was a replacement for the original Giant wheel . Hence the previous owner fitted voilamart wheel but fitted but the cable Which is threaded through the axle and the wires are directly soldered to the board.. no wonder I can’t follow you . So what...

Had a wheel spin out and had some advice from v helpful guy but his instructions are unclear . Please can anybody tell me How I do a cable continuity test with multimeter on this photo attached . If I need to get underneath the board how is it removed please ? Idiots guide please it’s new to me...

I appreciate your help really but Please clear message please you said this Follow the cable out of the motor until you come to the end. That's here the connector/s is/are. Please answer my question The wires out of the motor go underneath the board . So I repeat 1. Do I need to get...

I repeat my question . The cables appear to go underneath the board so I assume the connectors are underneath the board . My question is how do I remove the board Thanks

I repeat my question . The cables appear to go underneath the board so I assume the connectors are underneath the board . My question is how do I remove the board mum not working it’s a pity I can’t text or something so I can keep It goingIf I have query Thanks

Where’s the motor connectors . Under the PCB? If so how is the PCB removed please ? Also this multimeter doesn’t seem to beep when I put the two test pens together The display just comes up with different numbers . Sorry it does it’s just quiet . So I just need to know where motor connectors...

Will do thanks

ive got the Meter just need guide how to test . Also what about no R1 and R2 on the Ali express board