Search results

Soken's new Ionic Liquid Electrolyte, Double battery Capacity for EV Cars - YouTube

i think it is about time for me to say goodbye. i would like to say that i have engoyed most of my time on this forum. it is a pity that there are a few who will not let one have there say without scoring a few brownie points by trying to shoot one down in flames. having to explain the agument...

i dont know if anyone has got a123 batteries cheaper than this but this is the best that i have seen. i needed a complete bank of 18 for my Vpower 36v 20ah pack and i thought that it would be an arm and a leg but i found this site in america and purchaced all 18 for £27 ! and get this...

i need a dealer in the croydon area to obtain a new pedal sensor (broken wire ). thanks tk.

i have just aquired a second hand wisper works 905 se sport and have noticed that when in super low 1st or 2nd gear and i back peddle the chain gets thrown. at first sight it does not seem to be something that is easily rectified. is this a design flaw or is there some fix that can be done ? tk.

it would be helpfull if we could have a thread for upcoming and future events for bikers electric or otherwise. it could contain shows,get togethers, rides, special events etc. then i wouldn't keep missing them !.it would be handy if they were also in cronalogical order i dont know if this is...

have had my new lifepo4 for around 2 weeks now and have been topping it up each time i use it to 41v. problem is the low volt cut out cuts in after only around 3miles but the voltage still shows 38.8v. i think it may be that i have a 750w motor which is making the volts drop below the low volt...

after having blown two controll units through acidentily reversing the wires.i was wondering if you could make or precure a reverse polarity protection circuit of some kind. maybe along the lines of the household circuit breaker or a bunch of diodes wired in parralel. any ideas ? perhaps...

i seem to be reading replys to threads 1 hour before they are posted according to the sites time stamp. good trick, perhaps someone can tell me the winner of the second race at kemton tomorrow? tony

full on or off just finished new build using my exsiting motor and controller and tried to fire it up for first time. after trying several wiring combinations i just get two speeds either full on or off. am i right in concluding that my controller is kaput? can anybody confirm my fears. can...

is it possible to run on lithium batteries without the bms and only plug it in when charging ?

i was wondering, does the bms have to be conected at all times or can you conect it just for when its charging ?

have just bought my first watts up meter and need to know if the leads from the battery have to be the heavy 12g or can i take spur of in a lighter wire to run up to the bars ? no instructions supplied. also there is a smaller socket in the side of the meter ?:confused: any help...

i just wonderd why virtualy all (if not all ) manufacturers used blue heatsrink to cover lipo batteries, is this the colour code for lithium ? then again nicad packs always seem to be predominatly yellow ?

has anybody sucssesfully put a motor into a mag wheel?