KT-LCD2, KT-LCD3, KT-LCD6, KT-LCD8, KT-LCD10 replacement button assembly mounting bracket

Nealh

Esteemed Pedelecer
Aug 7, 2014
19,994
8,173
60
West Sx RH
Go to Daniels web site the link is in #39.
 

portals

Esteemed Pedelecer
Jul 15, 2022
430
136
So I was tightening the bracket on KT LCD 8 and managed to snap it where the screw goes through the loop :-(

I found Daniels website and ordered his 3D PLA printed replacement for £4.

Later on I found the .stl file on thingiverse so I've just 3D printed a prototype on my Creality CR6-SE (SUNLU PLA+ black at 220C/80C on magnetic PEI plate), as Daniels' hasn't arrived yet, it took approx 1hr 20mins at 0.2 res (low quality)/100% infill

I had to snap off rest of loop from controller to fit it however when you line it up and tighten screw it works well and holds buttons securely in place, I was a little sceptical but it does work great!!

It also 'lifts' the buttons by a few mm so I can slide it tight against my LHS brake whereas before I had to leave 3mm to stop it fouling.

Win win!

Currently printing another one at 0.12 res (high quality) now I know it works well.
 

Attachments