Need help removing speed limit

[davey_b]

Does anyone know which wire I have to disconnect in order to remove the speed limit?
I've attached images of the wiring from my controller, top set of wires got to the motor the bottom jumbles set end up in the pedal sensor, throttle etc...

Any help would be appreciated at this stage. I have contacted the company the makes the controller for a wiring diagram but not holding my breath on that one.

 

[eddieo]

what make is the bike?

 

[davey_b]

what make is the bike?

I have no idea, there are no markings on the frame at all. Attached a picture of it.

 

[schoe]

Looks like a Juicy Bike the seller is on this Forum you could ask him?

 

[JuicyBike]

My suggestion is the two grey wires. These should be linked to keep the speed below 15MPH for legal use in the UK. It is unlikely that any fiddling will increase the speed significantly beyond +3MPH.
What is the frame no. of the bike please, then I can tell you if it is one of ours or a cheeky copy.

 

[davey_b]

where would i find the frame number ?
I'm out and about at the mo but I have 2 of these bikes so it'll be good to know.
The grey connecter was already disconnected so I'm assuming the seller already knew about this. is there any way to boost its hill potential ??