The hardware has arrived a couple of weeks ago, but I was so busy lately adding mobile phone support to the Woosh Bikes website and Andy was also busy with writing the manual for it. The good news is we are now ready to start shipping.
This kit is only for 68mm bottom bracket shell. If you don't know if your bottom bracket is right for this kit, please email some pictures to kits@wooshbikes.co.uk
The kit is plug and play and it's very simple to put together. The crucial step is to replace the old bottom bracket with a new one.
I posted a short video here. As it was filmed with a mobile phone, it's nicer to watch it on my web page though.
WHAT IS IN THE KIT?
How does it work?
The left side (non drive) cup has splines which stop the bottom bracket body from moving.
Your pedalling force then creates a deviation of the inner shell which gets picked up by the electronics.
The connector has 4 pins: 5V, ground, PAS and Torque. PAS works in the normal way and can be used directly as is with a standard e-bike controller.
The torque output however is too weak to replace the standard throttle.
Andy is still putting the finishing touches to the manuals so you can't download the manuals quite yet.
Please let me have your comments.
Woosh hub kit with torque sensor
Woosh torque sensor kit with choice of front or rear hub motors. Convert your bike easily into an electric bike in record time.
wooshbikes.co.uk
This kit is only for 68mm bottom bracket shell. If you don't know if your bottom bracket is right for this kit, please email some pictures to kits@wooshbikes.co.uk
The kit is plug and play and it's very simple to put together. The crucial step is to replace the old bottom bracket with a new one.
I posted a short video here. As it was filmed with a mobile phone, it's nicer to watch it on my web page though.
WHAT IS IN THE KIT?
- 1) BBTS 68mm torque sensor
- 2) M5 LCD with 5 assist levels + 15A controller
- 3) Your choice of 44T or 48T crankset
- 4) Motor wheel of your choice in 20", 26", 650B or 700C*
- 5) Battery and charger of your choice 36V/48V
![](https://wooshbikes.co.uk/05/bbts/bbts-800.jpg)
How does it work?
The left side (non drive) cup has splines which stop the bottom bracket body from moving.
Your pedalling force then creates a deviation of the inner shell which gets picked up by the electronics.
The connector has 4 pins: 5V, ground, PAS and Torque. PAS works in the normal way and can be used directly as is with a standard e-bike controller.
The torque output however is too weak to replace the standard throttle.
![](https://wooshbikes.co.uk/05/bbts/bbts-details.jpg)
Andy is still putting the finishing touches to the manuals so you can't download the manuals quite yet.
Please let me have your comments.