It's written in EN15194!House of parliament law or your opinion ?
Not in any legislation I’ve seen, certainly not EU law
If true, you might note 48v battery fully or even half charged breaks your rule
please elucidate facts not utter bs !
It's written in EN15194!House of parliament law or your opinion ?
Not in any legislation I’ve seen, certainly not EU law
If true, you might note 48v battery fully or even half charged breaks your rule
please elucidate facts not utter bs !
Still in the box waiting for nicer weather.Didn't you buy one of those? What's your conversion like to ride?
Perhaps leaving out the term "nominal" when mentioning voltages is a convention used by writers of standards, and one mere mortals aren't made aware of?One would expect the EN15194 to be 48v nominal and not max as the max figure is stupid one that makes no sense , who builds and uses 11s ?
I wish you'd get on with it! There's been so much speculation on that horrendously contentious To7OrNotTo7WhatWasTheQuestion? thread, despite myself I'm curious about the TSDZ8, and I don't even want a torque sensored bike. Cold weather be damned, be the first to review! Or keep it refrigerated, like all cheeses it'll go off past it's use by date trapped in a box, lonely in deepest inky dark.Still in the box waiting for nicer weather.
- why is the anti-torque hanger no longer need (that's really good new BTW) - is the 'triangular' retaining clamp more serrated than the one for the TSDZ2?Gone is the anti-torque hanger on the TSDZ2B.
yes.- why is the anti-torque hanger no longer need (that's really good new BTW) - is the 'triangular' retaining clamp more serrated than the one for the TSDZ2?
On the TSDZ8, it's about 11mm-12mm.And can you tell me what is the gap between the crank axle housing and the main motor body (see pics below). On the TSDZ2 I estimate it is roughly 6.5mm at point 'X' and this is what it makes it a really tight for some frame/BB combinations.
Yes.The final mounting position of the motor looks to be 'swung forward'
Still not. Search the net if someone has managed to fit an BBS01 to your bike. If there is, then you'll be OK because both have the same footprint.I wondering if the TSDZ8 might work with one of my bikes that has an eccentric BB - any thought?