Zero assist option

[eFred]

Have a King Meter KM529 display which works fine but doesn't allow the bike to have the display to remain on with no power to the motor. Is there a replacement controller that would do this. Currently has 5 power options from 1 to 5 but no 0. Any ideas on this would be appreciated.

 

[vfr400]

Put a switch on the pedal sensor 5v red wire to enable/disable it. That way you can go from whatever level you want to zero assist and back again with a single press.

 

[Woosh]

similar idea but a little easier, put an extra switch on the brake sensor line to simulate squeezing the brakes when you want zero assist.

 

[eFred]

Don't have the plugins for the brake sensors which is the way I did it on the last bike. Hadn't thought about the pedal sensor so the pedal sensor is the way to go. It'll be a lot cheaper than a new display as well!
Thanks for the replies.

 

[TopEParts]

Have a King Meter KM529 display which works fine but doesn't allow the bike to have the display to remain on with no power to the motor. Is there a replacement controller that would do this. Currently has 5 power options from 1 to 5 but no 0. Any ideas on this would be appreciated.

Actually it's possible to update the display with a new firmware to add PAS 0 level.
For your reference: https://topeparts.com/product/km529-lcd-display/