I’ve foolishly removed the 3 stepped planet gears from a Q128 WITHOUT first marking up their respective angular position.
By trial & error I’ve managed to get the gears to mesh together, but the motor is noisy and underpowered.
Is anyone aware of a procedure to reinstate the correct gear phasing? There are no obvious marking on the gears unfortunately - the blue pen marks on the picture below are just my random scribblings.
By trial & error I’ve managed to get the gears to mesh together, but the motor is noisy and underpowered.
Is anyone aware of a procedure to reinstate the correct gear phasing? There are no obvious marking on the gears unfortunately - the blue pen marks on the picture below are just my random scribblings.
