Hey. So after eliminating a mid motor kit for my bike I am looking at getting a 250/1000w switchable rear hub and battery kit. So my research brings me to torque arms and their importance especially on aluminium frames which mine is. However I am still not 100% on how and where to fit them. Firstly am I right in thinking I should be using two, one on each side? If so will there be room for them and also I am not sure how I need to fix them for my bike. I have attached photos of my rear forks and I notice there is a threaded hole on each fork not being used (forgive my lack of knowledge) so is that where the arms can be secured to the forks?
Will two even fit based on 5-8mm each arm?
Looking at the images do you think the bike with torque arms will be suitable for the torque involved. For what its worth I will only be using the 250w mode 99% of the time and maybe have a little more fun on my brothers farm once in a while and maybe up any ridiculously steep hills once in a blue moon. I want distance over speed so the bike wont exactly be being thrashed at high power all the time.
Lastly can anyone advise any decent torque arms suitable for my bike.
Thanks guys.
Will two even fit based on 5-8mm each arm?
Looking at the images do you think the bike with torque arms will be suitable for the torque involved. For what its worth I will only be using the 250w mode 99% of the time and maybe have a little more fun on my brothers farm once in a while and maybe up any ridiculously steep hills once in a blue moon. I want distance over speed so the bike wont exactly be being thrashed at high power all the time.
Lastly can anyone advise any decent torque arms suitable for my bike.
Thanks guys.
Attachments
-
2.6 MB Views: 31
-
1.9 MB Views: 29
-
2.3 MB Views: 27
-
2.3 MB Views: 27