Search results

Halls fitted motor running Thank you all gentlemen fir your patience and support

Face with less surface area facing out thanks . Don't understand the previous bit sorry

Nealh I assume this photo shows what u mean by dovetail. Should the dovetail face outward or inward or doesn't it matter Thanks

Thanks nealh I'll update when I get to it

Thank you . But whatever it is, am I right in saying that those legs are not electronically connected to anything ? Only the top part soldered to top surface ? If so I can be a bit tough with the bottom bit once I've removed solder at the top

Just wanted to point out that I don't expect people to reply immediately to my questions . I have to wait I understand that .only I might give a prompt sometimes because I work a lot , so when I'm free to look at the bike I don't want to waste the opportunity . If I have to lose that...

Good. Cani u help ref removing the sensors ? IM not sure how they are attached below the board see my photo on previous post don’t know if they’re glued underneath can u advise

Thanks wheezy sorry it caused a short. I'll plough on with removi g the sensors but sorry I need help for this . Looks like the sensors pins below the board are either glued or wrapped . Dunno best way to remove them

Gotcha but wouldn't PAS work without throttle on a working bike Anyway? After all if you were using pedal assist you wouldn't use throttle necessarily at same t ime .my point was more about if the throttle was faulty disabled blown whatever , would pedal assist still work ?

Wheezy should the pedal assist work irrespective of whether the throttle is working or not ? It's me that mentioned the throttle I know but if the motor should work eventually with only pedal assist I'd rather solve that first then check the throttle cis it's a pig to get at . Then I can try...

Try to summarise now all tests 1. All halls tested for short and continuity 2. Phase wires beep from motor to controller end and across colour too 3. Phase wires beep cross colour at controller connection 4. MOSFETs phase wires show readings of 1 on power and 400 ISH on ground NB .. phase...

Phase wires . There’s 2 blue and 2 green going into the motor. 2 from motor to cable and 2 from motor to PCB . Are all 4 supposed to be continuous with cable at controller end ? And secondly do I need to disconnect the phase wires from the controller connection to test the cable ? Just this...

Mosfets double checked call showing 400s to ground and 1 to power

Sorry if it’s hidden in these posts somewhere but for cable tests does it makes Any difference which colour probe goes to motor and controller end .? I get a beep on all for continuity. But for cross wire all’s ok no beeps but some cross wire checks show 1 , and some show readings in the...

ThAnks . I was jokin really . I quite enjoy your verbal jousting haha . Won’t look at throttle till I redo all cable tests prob Sunday

Late home and early out today means I will continue at weekend . I sure you’ll be all glad for the silence

Dont hold back wheezy . Which one is the signal Plz ? Please Leave Me out of your verbal battles I need all 3 of your input

now now does t break up the team spirit So if I do your cross wire test at controller end and I do their full length controller to red circles test , I’ll have done both young methods of testing , which makes double sure and may possibly show different results . But importantly I have no...

Question to all 3 please . I may misunderstand . But why does Nealh and wheezy cable test involve cutting insulation at motor end but vfr second test to just outside axle only involves getting a probe below the shrink wrap