Search results

Which is signal wire plz

While I’m waiting to get to the cable tests , I need to eliminate something which hasn’t been mentioned Does the throttle mechanism have a mini circuit or wiring that could blow ? And if so could that impact on the pedal assist side of things ?

Work wise busy so looking like phase wire test by Friday and attempt to remove sensors weekend

Ok I’m sure I already did cross colour test from you’re earlier instructions but I’ll repeat it . The test from inside to just outside axle remains to be done. wIsh I understood how that cross colour routine works for continuity . But I’ll just get in with It When home Thanks all

If you have different opinions I’ll just have to do both ways

I’m lost . You’re saying controller end to circles and vfr is saying cross color test at controller end and continuity from circles to just outside axle

only put battery side on with one screw in battery housing and one screw in battery terminal plug

I don’t know who is saying what sorry vfr . So is my understanding above correct ?

Ok I’m sorry I’m lost now . I Already did a test between the different phase colours at controller end and Nealh Said I’d confused that with the mosfet test . So Nealh and vfr are saying tests from controller to the red circles. And I think you are saying test across the colours for continuity...

Halls definitely done . Upper small circles were done . Lower circle into the motor not done . Will do many thanks .

Thank you . You know the worst job I had this far? Trying to line up the bloody holes for the screws to put the pedal/Battery housing Back on .

Thanks again

Thanks Nealh . I assume you mean just immediately outside where they Disappear into the motor . I dint have to try and get into the motor where they disappear

Sorry think I misunderstood you. You advised to check sorry I’m confused . The on off switch on the handle bar gives power to pedal assist as well as throttle . Neither would work if this is switched off . (With a working motor of course) Only clarifying cos u refer to it as throttle on/off...

yes I have a throttle like this with a power and battery indicator next to it. That lights up , must admit I thought the throttle and the on switch were 2 separate things . I’ll check the lamp wire when home so I think I checked thick cables from controller To board but noT those goinginside...

1. Well I’ve got the new sensors so I might as well try them . Though I think it will be a pig of job to remove old ones . 2. The power / battery switch turns on Does that mean controller ok ? 3. I was advised to do continuity test from controller to solder points which I’ve done. And the...

Probably didn’t . I’m quoting the solder guy

Gotcha

Wish one of you guys was bit closer. I’m sure you’d find out quickly what was wrong if you had it in Front of you