Search results

If the controller got wet inside then it is most likely it has blown, the controller is a Lishui model so all you need to do is replace it with another 48v Lishui model. Problem is you won't find a 48v Lishui they are like hens teeth. You can get 36v ones but that is no good if you have 48v. If...

Never assume, measure and double check. If not sure buy/use a Vernier, even a steel tape measure/rule would have shown 31.6 to be over size. Most seat posts usually have the size somewhere marked on them.

Soldering cells in Parallel and series is a bad idea.

The last one to post his finish design on here was d8veh a about three years ago where he made them for his Rocky Mountains, one in Green and the other in Maple Leaf motif to match the bike perfectly, before him Amigafan used to show his striking end results

Aluminium welding not one for me Kyle, I shall stick with the tried and tested Grp process and a rattle can or two for colour matching to my bike.

:eek: Blimey Plagiarism on the forum, I thought I had posted under an alias. Not a very original post.

It doesn't matter how wobbly or erratic a cyclist looks, vehicles should be taking this in to account and progress accordingly with care, problem at the mo is that most out on the road currently don't have a brain. Even when out in my car I see cars speeding, tail gating and quite a few taking...

If jerky under PAS use look at two setting under PAS tab , see what the ' Start C% ' is set at, 10 -20% offers less strain from a standing start. Also look at 'Slow Start mode' , If it is set too high then power delivery ramps up too quickly and can be jerky at start up a setting or 4, 5 or 6...

It's fine pointing out legalities of using kits or derestricting, but if posters are unhappy with someone doing so there is no need to use abuse or ***** language to express ones self. If unhappy with someone and posters can't remain polite then they should refrain from replying. It is up to the...

Yours is a freewheel so you need that type of specific tool and not a freehub/cassette tool. Check the motor cable outer sheathing where it enters/leaves the hollow axle for cuts/breaks as this can lead to phase or motor hall wire damage at that point other wise just be careful with the motor...

The betting is odds on that with no battery or charger the bike probably is dodgy and stolen goods as that is the common scenario. Without evidence to prove other wise I won't offer any help.

That is one size controller, the shelves for the packs to sit on is a must I think. Now all you have to decide is to make it for real.

Not generally. One incident not far away a 78 yo rider in critical condition, a local man arrested for dangerous driving. I would say most will be down to poor driving / lack of due care & attention. I think a lot of us have seen speeding more then usual and some of it mor then excessive.

When I start mine, I will add the process to the Roadrat build.

My idea is to make the mock up like you, lay matting internally on a greaseproof paper lining where the face inside will be the finish ext face. Once the mould is removed the gp paper is easily peeled off leaving a ultra flat/ smooth finish with no need for a very fine mesh layer. The frame...

Sounds like a very handy option.

The mock up out of card is always a good idea, what materials are you going to use. Watching with interest as I am thinking of a similar task, probably out of polyester grp strong and lightweight.

Yes, build all my wheels. No 3d. Oki

Since the lock down roads haven't become safer for cycling, the fatality rate is currently about double the usual rate. For the most part the worst drivers are still prevalent and from what I see speeding & lack of due care at / approaching junctions / roundabouts. Latest met figures show an...

Oxydrive by H7 engineering no longer sell the kits so no longer any spares available.