Search results

The cheap ones (£5 or so) on ebay are fine, but make sure you get one with the buzzer for continuity testing. The only issue I have with them is the probes wiring, all the ones I have had the wire solder on the pin eventually breaks due to the free rotation of the wire at the top. Hot glue the...

The Panda mid drive aka a bbs01 ?, being a customer unit re-logoed may well be programmed to the customers requirements. It is possible the throttle only works once the pas has kicked in.

Error 30 comms abnormal, the fault is as mentioned above caused by a faulty; Contoller. Lcd . Main trunk cable. If the fault isn't a trunk cable issue then comms data is supplied back and forward via the Rx & Tx lines so would suspect a controller issue.

I have Nex on two 700c bikes both forks have over 3k miles on them, no marks or blemishes on the slides rust will only appear if left out in all weathers. Occasionally I give mine a wipe and a little spray of MO94, though a silicone lube will be better being non greasy.

lcd3 is a smaller compact screen with integrated side toggle buttons, not got one but screen details may be less then the 2 or 5 model. Also available is a portrait lcd6 model like the 2 & 5 model have the separate toggle buttons. All can be seen here...

Hi Kirstin, Ebay of course, I will find the link. As you can see up to 4 lines of engraving approx. 20ish letters max per line. Delivery is 4 days, you have to order the plaque then message the seller with your engraving details...

Battery connections aren't an issue as it's fairly easy to swap them/solder different ones on, though bullets are quite common on kits. The China celled battery has the unknown quantity of cell amp rating probably at best max 5a possibly less, even the the poor old Samsung 22fF & 26F were only...

Woosh sell 250w SWX02 kit.

My silly sticky label peeled off on my Q128C and now sports this small tiny plaque. Quite nice for £2.99, only problem is the slight spelling mistakes :rolleyes:.

PSWPower have a Dutch/German warehouse as that's where they send their no EU tax stuff from, if you are lucky and it is sent from the EU there will be nowt extra to pay.

The fuse can easily blow if the battery is already on when connecting, the main thing is the fuse did its job so protecting the battery from harm. Quite often it's the simple things that usually stare at you in the face, when leccy components don't work you have to stand back and put your logic...

I once tried contacting them and never got a peep out of them so never used again.

Hi Jonk, You will need to decide which route to go regarding motor watts, whether to stay with a legal one or to go for more W's. LCD with 5 pas levels with torque control controller ( like the KT models from PSWP or BMSB) gives more choice, levels 4 & 5 are undiscernible on flat ground but...

The battery is 480 wh , a reasonable rider can use about 10-20wh per mile depending on terrain at an average of about 15mph. A lot will hinge on the controller amp rating used and the cells used inside as well as the power control used, 2 hrs run time may be possible. Too many variables to be...

2hrs continual climbing might be achievable with moderate hills with some 10% inclines though you will need a low rpm wound hub and be able to keep the speed above 7/8mph. The Xiongda will be better but you are in to 250w+ rating in EU, depends on how active plod are over there in checking.

TSDZ2 in link below or on aliexpress. http://www.pswpower.com/peng/pic.asp?ModID=PicS224&TypID=S220008

Q100 is no more less legal then Q128, both have a nom power rating of more then 250w.

If you have a DVM you can check the fuse is ok with a voltage reading from the battery output terminals.

For the EU you most definitely need a 250w complaint hub unless you fancy taking a risk with 500w. Complete kits available from Panda bikes or Woosh alternately kits available on ebay. The SWX02 would be a good starting point for a legal kit.

We don't know the battery you have however the charger will indicate red when charging and green once the balance charge has finished, though generally the battery will always have enough voltage to allow the LCD to switch on. The battery sends power to the controller then power is supply to the...