Search results

I had thought of that, and tried it, but on the charger I was using, my original Swytch Brompton one, the charger did not detect the battery, so I did not try any further. I suspect this charger does not turn on until it sees the battery, and with the diode in place there is no battery voltage...

Can you tell us which canal you live next to ?

Indeed, the nylon mat bottom of the OEX, is a key factor in stopping the legs dissapear into soft ground.

Ask your local Council, they may take them for free. Dont sell it on eBay.

Try one of these Ultralight chairs, small when packed, 35cm long x 10cm diameter, 1.2Kg. Very comfortable. Not as easy to assemble as a standard folding camping chair, but then they weigh a ton and are huge packed.

I used to take somthing very similar out when walking in the hills, agreed, well worth the few grams. But I also cheated a bit, I cut up the ground sleeping mat you would normally take camping, into 3 pieces, joined it with gaffa tape and used it (folded) as a liner for the back of my rucsac. I...

A question. The constant voltage charge at the end of a Lithium battery charge, starting at say 4.18V per cell, adds in my tests around 7% of the capacity. I have a generic Solar panel type adjustable charger, but although it goes into the constant voltage mode at the end of the charge it...

I accept Paypal. This is where I used to work in the early days, I only discovered the existance of the video a couple of months ago. I ran the Electronics lab, fixed the difficult stuff, checked components for suitability etc. Not many eBike using Lithium batteries in those days mind.

I assure you I could measure voltages for several years even before I spent 3 years in college doing electronics.

Take the example of a single lithium cell. There are numerous chargers out there that will keep applying charge current till the voltage across the cell reaches 4.2V, then charging stops. For sure when the battery is then allowed to rest a bit the battery voltage falls to say 4.15V. Most...

So the lost capacity, 16.66%, is in line with my discharge tests and is considerably more than some suggestions that the capacity loss is only a few percent.

If by that you mean that cooking a chicken at a lower temperature (charge current) for longer, then yes its likey the chicken stands a better chance of being fully cooked (fully charged). The problem I have with that analysis is that the longer you cook a chicken, in general, the smaller it...

The 24% was the amount of Ahr, not time. At the relavent voltages the amount of charge in was; 41V, 3.56Ahr 41.5V,3.81Ahr 41.8V,4.32Ahr > constant Volt charge begins. 42V, 4.64Ahr > charge stops.

When my battery, which had been charged to 42V, was discharged, it went from 42V to 41V almost instantly, but that says nothing about what the capacity would be when the charge is stopped at 41V.

Not a meagre welding mask, use one of these;

I do understand that just stopping the charge at 41V does not complete the charge in the sense that the constant voltage part of the charge, where the current tails off to zero is missing. The balancing, if needed, is also missing. With the battery I was testing, 24% of the total charge in...

Have you, or anyone else, charged a battery, from low, to 41V, stopped the charge and then tested the capacity ?

I use a power meter and a bit of patience, when the voltage indicated on the battery goes to 41V, I stop the charge. Strange question really.

Not every time. Youneed to use a soft faced hammer, nylon or rubber, as less damage would be done during the dismanteling.

I dont see that knowing the apparent amount of charge lost when a battery is charged to 42V and then discharged to 41V is of much value, its not the same as charging to 41V and then discharging from there and thus measuring the batteries real actual capacity. Here is the discharge plots with a...