Hello All
My bike has been going graet for 18 months, then started to have intermittent fault.
I use it as a pedelec and do not have a throttle.
I took the cover off the controller and could see when the motor was working there was an internal LED that was flashing.
So I purchased
Controller 36V 250 W
A 790 display
A new loom
These were fitted.
I hade to cut the motor plug off, as it had the Hall effect wires in a combined plug.
I understand that these 5 wres do not need to be connected (they were not present with the old controller)
I could not get the motor to run, tried all combinations of new and old parts.
then I realised that the pedelec sensor illuminating and flashing.
So I ordered on of these from the same supplier.
I can measure the battery voltage 41V.
But still casnnot get motor to turn.
I am sure the motor is not at fault as but its the only thing I have not changed.
Any suggestions on what I should check.
My bike has been going graet for 18 months, then started to have intermittent fault.
I use it as a pedelec and do not have a throttle.
I took the cover off the controller and could see when the motor was working there was an internal LED that was flashing.
So I purchased
Controller 36V 250 W
A 790 display
A new loom
These were fitted.
I hade to cut the motor plug off, as it had the Hall effect wires in a combined plug.
I understand that these 5 wres do not need to be connected (they were not present with the old controller)
I could not get the motor to run, tried all combinations of new and old parts.
then I realised that the pedelec sensor illuminating and flashing.
So I ordered on of these from the same supplier.
I can measure the battery voltage 41V.
But still casnnot get motor to turn.
I am sure the motor is not at fault as but its the only thing I have not changed.
Any suggestions on what I should check.
Last edited: