Can I reprogram speed if my handlebar thingy looks like this?
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/192418578861
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/192418578861
Michael, I have already explained what you can do. You can install a throttle, that will run unrestricted. Or you can change the controller for the one I mentioned in the other thread. These are the only ways to derestrict your bike
Sorry I bit a little hard, needed coffee... Anyway it's pretty small and fits in the Carrera box which is also rather cramped so it should do, if I remember right it might be a tiny bit wider but more or less the same size. In my particular motor the black and the white (which is the usual speed sensor wire) come from the same braided wire inside the cable, so it's getting speed information from the hall sensors. I think I remember you asking about a white wire which is why I mentioned it. I have unplugged the white as was getting inaccurate speed readings and it still works so the white wire isn't necessary. These controllers work pretty well for a cheapie just wish the Speedo and odometer were accurate, they might be for a more common motor like yours thoughGeez, sorry m8, noob obviously. What black wire? I have a 8 wire motor,black is gnd for the hall sensors is it not?
Also are they both same size cos the controller box has little extra space.
Thank you so much, if I can use it, I will buy it.
I just checked again, I'll have to contact the seller cos he doesnt deliver to my place.