New ktlcd3 and controller

[Parsons]

Hi guys as you know from my other post I knackered up and lcd3 display. which would not match my old controller . I have a new one with matching sim wave controller all working fine . But need a little more help with c2 setting something to do with phase and magnets 0 to 7 on the settings all I know my rear hub wheel is 1000w . 3 phase and hall sensor don't know how many magnets can you help thanks

 

[Nealh]

On all my hubs C2 is 0 if I try other values they run rough.
Try value 0 and if your hub is ok leave it alone other wise try all 8 values but don't use the throttle to test as full amps may cause damage with wrong value, always use PAS for testing drive and once you are happy with the hubs running in upper PAS levels you can use throttle.

 

[Parsons]

Thanks mate will try it on 0 first thanks again

 

[Parsons]

Sorry for got about P1 and P2 settings sorry to ask

 

[Nealh]

P1 46 (will be close ) for D/D hubs you can confirm the speed read out with gps.
Longwinded more accurate P1 setting.
https://www.pedelecs.co.uk/forum/threads/q100-motor-–-parameter-p1-explained-–-speed-alignment.33072/

P2 if the hub has internal or ext hall spd sensor value 1 or 6 for odo reading, other wise 0 though don't think you will get a odo reading when freewheeling as speed is roughly calculated via crank rotation.

 

[Parsons]

Thanks mate you been a big help