I have a spare back wheel for my bike (without motor). And I would like to get another front wheel and fit knobblies so that I can convert my MTB back to std from time to time. Currently the controller is bolted under the saddle so I was thinking i would get another post and saddle to do a quick change. I would disconnect the wire going to the throttle and just tie up but that leaves me with the rest of the wiring.
At the moment this is cable tied at various locations to the back of the bike. Does anyone use or have any recommendations for quick release ways of attaching the wires to the bike?
thank you
Halflife
At the moment this is cable tied at various locations to the back of the bike. Does anyone use or have any recommendations for quick release ways of attaching the wires to the bike?
thank you
Halflife