Recent content by Gooseman

Voilamart 250w 36v rear wheel https://www.ebay.co.uk/itm/36V-250W-Rear-Wheel-Electric-Bicycle-Motor-Conversion-Kit-E-Bike-Cycling-Hub-26/224126208985?epid=22027211542&hash=item342ef68bd9:g:rCEAAOSw93dfJQas

thats their new listing 13cm/130mm the one i bought in april is 15cm/150mm.

it's a voilamart 26" rear wheel conversion kit purchased back in april (Their new listings show them to be 13cm between dropouts).

Looking to change my bike to a new one as i built my first ebike on a old and not great condition bike that i already had to keep the cost down. Having tried a carrera crossfire 2 i would like to buy one of these and transfer the kit but have a couple of issues. The dropouts are only 135mm Wheel...

Recieved today and fits perfect and feels much stronger than i expected it to and i would say stronger that the original. Once everything is back together you wouldn't notice it had been repaired. I used the same screw that came with my LCD3 and didn't have any issue with mine. Good to hear you...

No problem i'll cut that off and thanks for letting me have one.

Hi Dan if you still have any left i would appreciate one for the lcd3 mine is broke on the bend that the bolt goes through.

Sorry that's what i was asking nealh how he did it.

Do you have a setup that you can adjust to cutoff at 3.9v or do you just keep checking with multimeter?

Thanks if the uv glue doesn't hold then i will look into using a clamp as you suggest.

I've got the broken off bit but didn't think it would glue well on the bend but i see from watching youtube on the uv glue you linked to i can build up layers so will give that a go cheers.

Switch is broken where it attaches to the handlebars. Is it possible to buy the switches for the lcd3 or just available as a complete unit. If not available are there any 3 button alternatives i could wire up?

That's it working now thank you

Thanks i'll give that a go.

Trying to get cadence sensor/magnet attached to this crank if i use the first 12 pole magnet and place behind the nut there is no thread left to put the nut back on, if i place it on this side of the nut i can't get it to sit properly has a major wobble so the sensor would only pick up maybe...