Search results

If the battery only uses a two pin/wire connection then yes you can wire in a generic battery to use as long as the existing battery is isolated.

The graphs show single cell testing, hence why the side scale reading 2.9v - 4.2v. The Wh is the individual cell wh capacity.

A couple of graphs showing discharge using two fairly widely used cells. This Orbtronic is a Panny PD/PF re wrap

Try this. BIGSTONE C500B-LCD INSTRUCTIONS MANUAL Pdf Download | ManualsLib

You have to count the pins in your motor connector and the any intended one for use.

What if the bloke had been a child or a disabled person, one just can't ignore one's own duty of care ? The op stated the following so should have taken a bit more care . [ "It's always the same at pub closing time: drivers and pedestrians wander about blind"].

If an accident had occurred the op would have had some dejavu and gone down the line as he did with the badger.

One would still have a responsibility to be aware of pedestrians on the footpath, if you had hit him part of the blame would have been at your door. From the footage it is evident he was approaching the road at the angle of the track he was walking, so whether or not a crossing place is...

If the motor cable connection is the same then yes.

Try the orange wires then, unfortunately with no instructions to go on one can only try.

Nothing new, drive shaft bikes have been tried and built over here many years ago. Kirstin who once posted frequently on here had a Sussex shaft drive bike for commuting.

cut off speed for pedal assist.

Nearly, when the bike is running correctly switch off first so that it, the memory the controller remembers then disconnect said white wires.

Speed wires when connected slow restricts the speed. First things first is to get the learning sorted out, each time the controller is disconnected it needs to be done.

Are they learn wires or speed restriction wires ? If the former one has to go thru the learn process to get the right phase/hall sync once the motor is sync'd and running properly turn the bike off and then disconnect the learn wires, the controller should then remember the correct sync. If not...

If the screen switches off immediately then a connection issue, a faulty voltage regulator in the controller or a dodgy wire connection in the display. A short in nay 1t4 trunk cable. The power failing once the throttle is used is a short possibly or maybe back to a battery issue. Having had...

The noise isn't mechanical, it is an electrical one. Did the controller have learns wires ? I can't remember.

The cover comes off with the motor and axle attached, the magnet housing will be on the peripheral edge of the inner side of the cover.

You will have to enter the P & C settings to look at the parameter settings, write then don and list them on here. Not much should need changing. When you sw on, within 5 secs hold the up/down buttons for a few secs and the basic display will flash. One can set the correct wheel size, cut off...

On the brake side one has to undo the inner axle nut so that the motor unit with axle can slide out from the RHS.