Search results

We don't give e scooter advice as this is a pedelec forum for e -push bikes , if you want to use an illegal e-scooter find a e-scooter forum.

9.5k ohms is absolutely fine for mosfets, ignore a lot all of the utube crap. As long as the fets all read the same you have no worries and replacing them is futile. All of my fets measure about much the same at 9.5k. Stuttering can be PAS pick up alignment incorrect or a connection issue with...

This one is 87mm. DIY conversion E-Bike KM-DISC12 PAS Disc Kettenblatt King-Meter (atmparts.eu)

My Bafang cst coming up to six years and 8k miles, it has been faultless pretty much, just a worn bearing to change. The AKM is about 4.5years now and again been faultless. Two BBS controllers and two GSM's failed and altogether pretty poor and less then half the mileage the Bafang.

Show a pic of the PAS installation.

With my Swizzbee #2 I simply replaced the Nimh with lithium celled packs of my own build, utilising the original controller.

Hub motor all day long for me simply for their reliability, my experiences with kit mid drives shows that reliability wise hubs are far superior.

One can also adjust sensitivity with C14 3 is max or 2 for medium.

C1 08 new one on me, I thought 07 was max. For D12L/12 mag disc then C1 02, if still no joy try pedalling backwards in case disc face orientation or sensor orientation is wrong. Ensure gap between disc/sensor is 1-2mm max.

Exactly Cwah you have highlighted the risks that those without the knowledge will and can cause damage, the guy may have been lucky as on another day the battery could possibly have exploded or gone up in flames. It simply isn't the logical route to take.

Taking primary is essential at narrow junctions or at lights to reduce the chance of close passing or being pushed in to the crap on the n/s, as is keeping up to a metre out from the n/s on all roads.

Yose must have changed the hub motor as my hub from #1 fits 135mm with no stretching, All my rear hubs are 135mm inc a AKM, Bafang cst and a Mxus.

Terrain and distance for riding ?

Roast BBS02 for Xmas dinner, nice.

At 1.1v per cell look at a lithium replacement, the controller shouldn't be an issue but make sure you buy a new charger with the battery.

Bafang BB clearance is about 6mm, Tongsheng I believe is less.

Yes, Merry Christmas every one.

The tabbed washers arn't torque washers but simply anti rotation washers, as one would find on a geared hub like Alfine/Nexus. One should use them as well as one torque arm/bracket.

20/25a is likely but then again so is 30a. No use the op using a controller if his battery can't supply the current.

The SMIDSY cop out is a good shout and is purely down to very poor driving and possibly bad drivers eyesight who shouldn't even be driving without correct specs. A lot of drivers we all can see where we live simply drive too fast approaching and manoeuvring at junctions, most now think their...